Hi,
We are using OME to monitor some HP switches. We have come to accept that they will remain as unknown devices however I am having some difficulties with the HP-SWITCH-TRAP-MIB.
As far as I can tell, this MIB assigns the model number of the switch to the alert generated. Below I have captured an example of an alert with the MIB and an example without the MIB.
Here is the alert with the MIB:
Image may be NSFW.
Clik here to view.
And here is the same alert without the MIB (I just blanked out the IP and name of device):
Image may be NSFW.
Clik here to view.
SO the problem I have here is that, with the MIB loaded, then the alert does not give any details of the actual error itself, only that an RMON event has happened. But then when I take the MIB out then I get a lot more details on the actual issue (PVID mismatch) however the alert comes up as an unknown and I want to avoid this.
Am I doing something wrong? Is there any way to further customise the Trap or Alert?
